Balanced-audio REX II Preamplifier Manuel d'utilisateur télécharger pdf (Page 14)

will dim but never turn completely OFF. With the display OFF, issuing any

remote control command that would normally require a display change (i.e.:

Volume, Input selection, Fade) will automatically turn the display back ON.

MUTE Function:

The REX II has two mute modes: manual and automatic. The blue LED above the

Mute button goes ON when the unit is in MUTE state. To MUTE the REX II, depress

the MUTE button located on the right side of the front panel. Depressing this

button again will return the unit to its normal operation and turn the mute LED off.

When the unit is powered up it automatically self-mutes until the proper operating

points of the circuitry are reached. It will then automatically go into Play mode,

provided the Mute function was not activated (the blue Mute LED is Off).

Turning the REX II OFF even for short time, will make the unit reset its power

sequencing circuit and mute its output.

It will then require 50 seconds for the unit

to become operational again.

REX II PROGRAMABLE FUNCTIONS

The REX II programming functions allow the user to optimize the unit configuration

for any particular system set up. The flexible programming facility defines each

signal input with a group of user-selectable parameters that are then stored in the

unit’s memory. Every time a particular input is selected, its unique combination of

parameters is loaded into the operating memory. Programming is easy and is

accomplished through using just two front panel controls -: the

Function

button

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 24 25

Pas de commentaire

Balanced-audio REX II Preamplifier Manuel d'utilisateur Page 14