Balanced-audio REX II Preamplifier Manuel d'utilisateur télécharger pdf (Page 10)

Pin 1: common/shield

Pin 2: positive

Pin 3: negative

For the REX II, use the Main 1 XLR Output for connection to your balanced power

amplifier. The Output 2 is configured as an RCA connector output.

Single-Ended Components

Single-ended components have RCA connectors. The REX II preamplifier is

designed to work with balanced interconnects only. If single ended components

need to be connected to the preamplifer, then the RCA/XLR adapters should be

used. These adapters are available from an authorized Balanced Audio Technology

dealer at a nominal charge.

Two types of adapters are available:

Input Adapters: RCA Female to XLR Male

Output Adapters: RCA Female to XLR Female.

REX II FRONT PANEL CONTROLS

STANDBY Button and LED

The Standby button is used to turn the unit ON and OFF and to switch the

preamplifier into its Standby mode. The LED indicates the status of the unit’s

power circuitry and has four state:

LED OFF Display OFF Unit is in OFF state

Display ON Unit is in ON state

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Pas de commentaire

Balanced-audio REX II Preamplifier Manuel d'utilisateur Page 10